Amana appliance repairs in The Colony, TX
Amana appliances show up often in rentals, apartments, and starter homes across The Colony, valued for straightforward, largely mechanical designs that are usually simpler and cheaper to repair than high-end smart appliances. Our technicians know Amana's parts and error formats and carry them on the truck.
Amana issues we see most often
Here's what tends to go wrong on each type of Amana appliance, and the service page to visit for the full breakdown and cost guide.
| Appliance | Most common failure | Full repair guide |
|---|---|---|
| Refrigerator | Simple two-letter alerts like PO, HI, LO, and CF pointing to power loss, temperature, or board communication issues. | Refrigerator repair |
| Washer (top-load) | Suds, overload, and off-balance codes, often resolved by adjusting load size or detergent type. | Washer repair |
| Washer (front-load) | Control lock and detergent dispenser detection issues on newer models. | Washer repair |
| Dryer | Vent restriction and belt wear on straightforward mechanical dryer models. | Dryer repair |
| Range | Igniter failures on gas models and control board issues showing F#-E# codes. | Oven & range repair |
Why Amana repairs tend to cost less
Amana's straightforward, largely mechanical designs are easier to diagnose and repair than appliances loaded with smart features and touchscreens. Most repairs stay well under half the price of a replacement, which is almost always the better value on a working appliance.
- Belts, gaskets, and seals wear out after 6-10 years of regular use
- Most repairs run $200 to $400, far below replacement cost
- Improper installation — an unlevel washer or a fridge too close to a wall — causes premature wear
- Unusual noise is an early warning sign — it gets worse, not better, if ignored
Common Amana refrigerator alerts
Unlike some brands that use numbered fault codes, Amana refrigerators display short two-letter alerts. Here's what each one means.
| Alert | What it usually means |
|---|---|
| PO | Power outage occurred — the fridge is telling you it lost power and warmed while nobody was watching. |
| HI | A compartment is running too warm, often after a door was left open or a cooling fault developed. |
| LO | The freezer is running colder than its setpoint, usually from a drifting temperature sensor. |
| CF | Communication failure between the main control board and the display board. |
PO and HI can both describe an event that's already over — check whether the compartment has recovered before assuming it's an active fault.
How we repair your Amana appliance
Here's what happens from your first call to a working appliance again.
Get your model number
We ask for the model number when you call so we can bring the right parts on the first visit.
Diagnose & quote
We confirm the exact cause, including reading any error alerts, before quoting a flat-rate price.
Repair with OEM parts
We use original manufacturer parts whenever available for your model.
Test & confirm
We run a full cycle or test before we consider the repair complete.
Every service, for every Amana appliance
From refrigerators to range hoods, see the full list of repairs we handle.
View all 12 servicesRelated brands
Amana is part of Whirlpool Corporation, sharing parts with these brands.
View all 12 brandsAmana repair questions
What homeowners in The Colony most often ask before booking an Amana repair.
What does PO mean on my Amana refrigerator?+
PO stands for power outage — it's a historical alert telling you the fridge lost power and warmed up while unattended. Check whether the compartment has recovered before assuming there's an active problem.
Why are Amana appliances typically cheaper to repair?+
Amana favors straightforward, largely mechanical designs over smart touchscreens and extra electronics, which makes diagnosis faster and parts less expensive compared to premium appliances.
What does the Sud code mean on my Amana washer?+
Sud (or Sd) means too many suds were detected, usually from using regular detergent instead of HE detergent, or simply too much soap for the load.
Is Amana part of Whirlpool?+
Yes. Amana is owned by Whirlpool Corporation and shares some control boards and platforms with Whirlpool and Maytag models.
How much does Amana appliance repairs typically cost?+
Most Amana repairs run between $200 and $400, plus the standard $60–$95 service call fee, which is almost always cheaper than replacing a working appliance.
What does CF mean on my Amana refrigerator and is it serious?+
CF means the main control board and the display board have stopped communicating through the wiring harness that connects them. It typically needs a technician to inspect the harness or replace the affected board.
Amana appliance showing an alert? Let's fix it today.
Call now for a same-day or next-day appointment with a local technician.