Standing water at the bottom of the tub, dishes that come out with food still on them, or a door that won't latch all point to a specific, fixable part. Our technicians diagnose the exact cause and carry the parts to repair most dishwashers the same day.
A dishwasher usually shows a few warning signs before it stops working properly. Here's what to look for.
Water left at the bottom after a cycle usually means a clogged filter, hose, or a failing drain pump.
Food residue left behind often points to a clogged spray arm, a worn pump, or a hard water buildup issue.
A dishwasher that stays silent when you press start often has a faulty door latch or a control board issue.
Puddles near the base usually trace back to a worn door gasket, a loose hose, or a cracked tub seal.
A lingering odor is often a sign of standing water and food buildup that needs to drain properly.
Wet dishes at the end of a cycle usually mean the heating element or vent isn't working correctly.
Here's what usually causes each dishwasher problem we see in The Colony, and the typical price range once your technician confirms the exact issue.
| Likely cause | What it means | Typical repair cost* |
|---|---|---|
| Clogged filter | Food and grease buildup blocks water flow — often just needs cleaning. | Under $100 |
| Faulty door latch or gasket | Prevents the dishwasher from starting or lets water leak out. | $75 – $150 |
| Worn or clogged drain pump | Pumps water out of the tub after each cycle — a common cause of standing water. | $175 – $400 |
| Faulty water inlet valve | Controls water flow into the machine at the start of a cycle. | $75 – $220 |
| Broken heating element | Heats water and dries dishes — replacing it fixes most drying complaints. | $150 – $425 |
| Failed control board | The circuit board that manages every stage of the wash cycle. | $250 – $500 |
*Ranges reflect typical parts-and-labor costs across the industry. Your technician confirms the exact price on-site before starting any repair.
Consumer Reports recommends replacing an appliance once the repair cost passes about half the price of a new model. Most dishwasher repairs stay well under that line.
Here's what happens from your first call to a working dishwasher again.
We check the filter, pump, valves, and door seal to find the actual cause of the problem.
You get a flat-rate price for the repair before any parts are touched.
Most parts are stocked on the truck, so the fix usually happens the same visit.
We run a complete wash cycle to confirm proper draining, cleaning, and drying.
We regularly service Whirlpool, Bosch, KitchenAid, GE, Samsung, and LG dishwashers found throughout The Colony.
A slow-draining dishwasher can sometimes trace back to a garbage disposal connection.
View all servicesWhat homeowners in The Colony most often ask before booking a dishwasher repair.
The most common causes are a clogged filter, a kinked or blocked drain hose, or a failing drain pump. If you recently had your garbage disposal replaced, a leftover knockout plug can also block drainage completely.
Most dishwasher repairs run between $75 and $500 depending on the part, plus the standard $60–$95 service call fee. Simple fixes like a clogged filter often cost under $100.
A clogged or damaged spray arm is the most common cause, though a worn pump or hard water mineral buildup can also prevent dishes from getting fully clean.
A bad smell usually means water is sitting in the tub longer than it should, often from the same causes behind poor draining. Left unaddressed, it can be a sign of bacteria buildup.
If the repair cost is well under half the price of a new dishwasher and the unit is under about 10 years old, repairing is usually the better value. Motor or control board failure on an older unit is the main exception.
Most repairs are completed in one visit, typically within an hour, since our trucks carry the parts needed for the most common dishwasher failures.
Call now for a same-day or next-day appointment with a local technician.